Edge-lighting Fast Jack 17 Port Canopies Without Transformers Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Oświetlenie Edge-lighting Fast Jack 17 Port Canopies Without Transformers. Edge Lighting Fast Jack 17 Port Canopies Without Transformers User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 3
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
SAVE THESE INSTRUCTIONS!
FJC-16RD-_
Installation Instructions for
Canopy Only
16" Round 5, 7, & 9 Port Fast Jack
Running the Power from a Remote Transformer to the
Fast Jack Canopy
1
904-FJC-16RD-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
A
© 2012 Edge Lighting. All Rights Reserved.
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.
REMOTE
TRANSFORMER
ELECTRICAL BOX
CONDUIT
MAX
20FT
- This product is ETL listed for indoor dry locations.
FAST JACK
CANOPY
B
Install the Canopy
#8-32 SCREW
1
1
MOUNTING PLATE
CANOPY
1: Loosen and remove the six #8-32 screws around the canopy
to remove the mounting plate.
1
C
MOUNTING PLATE
#8-32 SCREW
3
2
3
2:
through mounting plate center hole.
Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
Feed the low voltage coming from the remote transformer
3:
Przeglądanie stron 0
1 2 3

Podsumowanie treści

Strona 1 - Canopy Only

SAVE THESE INSTRUCTIONS!FJC-16RD-_Installation Instructions for Canopy Only16" Round 5, 7, & 9 Port Fast Jack Running the Power from a Remote

Strona 2

2DMOUNTING PLATE44: Mark the three mounting plate holes on the ceiling.5: Tap the anchors through the mounting plate holes onto the marked point u

Strona 3

3H10 10 9: Make sure that the mounting plate is grounded in accordance with local electrical codes.10: Connect each canopy wire to one low volt

Komentarze do niniejszej Instrukcji

Brak uwag