Edge-lighting Crystal Galaxy with Downlight Instrukcja Użytkownika Pobierz pdf

CRYGA__-12-__SN

Installation Instructions for Crystal Galaxy Suspension

and Crystal Galaxy Suspension with Downlight

904-CRYGA-01

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- Do not install fixture assemblies closer than six inches, or

as specified in the fixture installation instructions, to

curtains or similarly combustible materials.

- Ensure that power to the junction box is OFF before

beginning any electrical work.

- RISK OF FIRE: This product must be installed by a

qualified electrician. Turn the power to the electrical box

off during installation.

- RISK OF FIRE: Use only the type of lamp and maximum

wattage indicated in this instruction manual.

- This product is ETL listed for indoor dry locations and

approved to be used at any height above the finished

floor.

- This product is suitable only for indoor dry locations and

approved for the use at any height above the finished floor.

- This product contains a magnetic transformer with a built-in

dimming coil.

- This product may be dimmed only with a low voltage

magnetic dimmer. Using a dimmer other than specified may

work initially, but will eventually cause transformer failure

and void the warranty. The dimmer must be derated as

indicated by the dimmer manufacturer.

- Load the circuit of the surface mount transformer to

rated capacity only.

GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS

Determine and Adjust Fixture Height

1: Push the suspension cable into the center mounting standoff

to determine the desired height from the mounting surface

of the power supply to the bottom of the fixture. Refer to

Figure H for more details.

CRYSTAL

SUSPENSION

CABLE

CRYGA__-12-__-DL-SN

1 2 3 4 5

Podsumowanie treści

Strona 1 - Crystal Galaxy Suspension

CRYGA__-12-__SNInstallation Instructions for Crystal Galaxy Suspensionand Crystal Galaxy Suspension with Downlight1904-CRYGA-011718 W. Fullerton AveCh

Strona 2

Install the Surface Mount Transformer1: Loosen and remove the five M4 button head screws around the transformer cover with the provided 2mm Allen

Strona 3

39: Feed the extension wires through the transformer housing center hole. Slide the transformer housing onto the crossbar assembly nipple and

Strona 4

4J15: Connect one fixture power wire to the white 12VAC neutral wire from the power supply.16: Connect the remaining fixture power wire to the y

Strona 5 - metal frame

4M CRYSTAL METAL FRAME 22: Secure each crystal loop to a threaded post on the metal frame. Repeat until all crystals have been mounted to the

Komentarze do niniejszej Instrukcji

Brak uwag

Edge-lighting Crystal Galaxy with Downlight Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Oświetlenie Edge-lighting Crystal Galaxy with Downlight. Edge Lighting Crystal Galaxy with Downlight User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oświetlenie Edge-lighting Crystal Galaxy with Downlight