Edge-lighting Port LED Components Instrukcja Użytkownika Pobierz pdf

Installation Instructions for Port Round & Square LED

904-PORT-02

- WARNING: Fixture must be installed in accordance with

National and Local Electrical codes.

- Load cannot exceed the total wattage of the transformer

rating.

- This fixture must be installed by a licensed electrician.

- Use UL listed type UF underground cable when no conduit

is used to power the fixture(s).

- For outdoor installation, use outdoor rated electrical

boxes (minimum 1.5" deep), conduit feedings, and wire

nuts. For indoor installation use octagon electrical boxes.

IMPORTANT SAFETY INFORMATION

Outdoor Installation Using an Electronic LED Power Supply (TE-60L-12)

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

OUTDOOR

ELECTRICAL BOX

CONDUIT GOING TO

ELECTRICAL PANEL

BUILDING WALL

1: Install an outdoor electrical box onto the wall or post next to

the building to fit the LED power supply (TE-60L-12) and to

branch the power to all in ground electrical boxes

2: Install conduit and run 120 volt power wires from the panel

to the outdoor box.

3: Install conduit(s) from the outdoor electrical box to all in

ground fixture outdoor electrical boxes.

4: Run proper wire sizes from branching electrical box to all

fixture electrical boxes using the "Wire Size Chart" on page 6.

GROUND

NOTE:

maximum of 15 Port fixtures.

The TE-60L-12 electronic LED power supply can power

5: Connect the white LED power supply wire to 120 volt neutral

power wire with a wire nut.

6: Connect the black LED power supply wire to 120 volt hot

power wire with a wire nut.

7: Connect one 12 volt power supply (red wire) in parallel to

one wire going to each fixture electrical box with wire nuts.

Connect the other 12 volt power supply wire in parallel to the

other wire going to each fixture electrical box with wire nuts.

(See wiring diagram on page 6).

8: Place the LED power supply and wire nut connection inside

the electrical box and mount the box cover.

PORT-RD-ST-SA

PORT-SQ-ST-SA

NOTE:

fixture omit the steps below and refer to the "Outdoor Installation

Using Magnetic Remote Transformer" section.

If using a magnetic remote transformer to power the

SAVE THESE INSTRUCTIONS!

IMPORTANT INFORMATION

- This fixture must be powered with a 12 VAC magnetic

remote transformer (T-150-12, or T-300-12) or an LED

electronic power supply (TE-60L-12) only.

- For optical controls such as 20° beam tilt, micro louver or

glass lens use PORT-LL accessory (sold separately).

- When dimming use a magnetic low voltage dimmer with a

magnetic remote transformers and electronic low voltage

dimmer with an electronic transformer.

1.6"

2.4"

120VAC

12VAC

120 VOLT

WIRES (INPUT)

12 VOLT

WIRES (OUTPUT)

1 2 3 4 5 6

Podsumowanie treści

Strona 1 - Port Round & Square LED

Installation Instructions for Port Round & Square LED904-PORT-02- WARNING: Fixture must be installed in accordance with National and Local Elect

Strona 2

2OUTDOOR ELECTRICAL BOXCONDUIT BUILDING WALL31: Install the magnetic remote transformer indoor (unless it is rated for outdoor).2: Refer to the in

Strona 3 - Power Supply (TE-60L-12)

3NOTE:the steps below and refer to the "Indoor Installation Using Magnetic Remote Transformer" section. If using a magnetic transformer to p

Strona 4

Indoor Floor Trim Housing Installation42: Insert the provided plastic caps to all trim housing to prevent dust and debris from entering inside the

Strona 5 - Installation & Drywall

LPANELSTUDCONDUIT OCTAGON BOX WITHBRACKET2120VAC12VACPOWERSUPPLY3MAGNETICREMOTETRANSFORMER1: Install the magnetic remote transformer to an accessible

Strona 6 - Wiring the Trims

GROUNDKTRIM2NOTE:consumes 2.4 watts. Each fixture contains an integrated LED lamp. Each Port Wiring the TrimsLOW VOLTAGE WIRE SIZE CHARTTRANSFORMERWA

Więcej dokumentów dla Oświetlenie Edge-lighting Port LED Components

Aby wyświetlić dokument Edge-lighting Port LED Components Instrukcja Użytkownika

Edge-lighting Port LED Components Instrukcja Użytkownika (1 strony)

Komentarze do niniejszej Instrukcji

Brak uwag

Edge-lighting Port LED Components Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Oświetlenie Edge-lighting Port LED Components. Edge Lighting Port LED Components User Manual [en] Instrukcja obsługi

Podsumowanie treści

Więcej dokumentów dla Oświetlenie Edge-lighting Port LED Components

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oświetlenie Edge-lighting Port LED Components