Edge-lighting 2 Circuit Sloped Ceiling Power Feed Canopies Instrukcja Użytkownika Pobierz pdf (Strona 2)

CAP

3/8-24 SETSCREW

POWER HOUSING

MIDDLE

CONTACT

KNURLED

NUT

1: Unscrew the cap from the power housing.

2: Slightly loosen the 3/8-24 set screw on the cap with the

3/16 Allen wrench provided, (DO NOT REMOVE IT).

3: Slightly loosen the knurled nut on the power housing so that

the middle contact moves back and clears the power housing

opening.

Install the Monorail 2 Circuit to the Power Feed Canopy

CAP

POWER HOUSING

MONORAIL 2 CIRCUIT

4: Place the a section of Monorail 2 Circuit into the power

housing. Make sure that the Monorail 2 Circuit is supported

by the sloped standoffs. Refer to the instructions provided

with the standoffs.

5: Tighten the cap to the power housing. Make sure the

cap is not cross threaded.

sloped

CAP

6: Tighten the 3/8-24 set screw on the cap with the 3/16

Allen wrench for proper power connection.

7: Tighten the knurled nut for proper power connection.

HOT 1

HOT 2

CAM

KNURLED NUT

3/8-24 SET SCREW

3/16 ALLEN WRENCH

1 2 3

Brak uwag

Edge-lighting 2 Circuit Sloped Ceiling Power Feed Canopies Instrukcja Użytkownika Strona 2