Edge-lighting 2 Circuit 4" Round Adjustable Power Feed Cano Instrukcja Użytkownika Pobierz pdf (Strona 2)

CAP

3/8-24 SET SCREW

POWER HOUSING

MIDDLE

CONTACT

KNURLED

NUT

9: Place all wires and wire nut connections inside the electrical

box.

10: Secure the power feed canopy to the electrical box by

tightening the two provided #8-32 screws with the 3/32

Allen wrench.

1: Unscrew the cap from power housing.

2: Slightly loosen the 3/8-24 set screw on the cap with the

3/16 Allen wrench provided, DO NOT REMOVE THEM.

3: Slightly loosen the knurled nut on the power housing so that

the middle contact moves back and clears the power housing

opening.

Install the Monorail 2 Circuit

to the Power Feed Canopy

3/32 ALLEN

WRENCH

#8-32

SCREW

CAP

POWER HOUSING

MONORAIL 2 CIRCUIT

4: Place a section of Monorail 2 Circuit into the power housing.

Make sure that the Monorail 2 Circuit is supported by the

standoffs. Refer to the instructions provided with the

standoffs.

5: Tighten the cap to the power housing. Make sure the cap

is not cross threaded.

CAP

3/8-24 SET SCREW

6: Tighten the 3/8-24 set screw on the cap firmly with the 3/16

Allen wrench provided for proper power connection.

7: Tighten the knurled nut firmly for proper power connection.

HOT 1

HOT 2

COM

KNURLED NUT

3/16 ALLEN WRENCH

1 2

Install the Canopy 1

Komentarze do niniejszej Instrukcji

Brak uwag

Edge-lighting 2 Circuit 4" Round Adjustable Power Feed Cano Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oświetlenie Edge-lighting 2 Circuit 4" Round Adjustable Power Feed Cano